

Suitable product for elevators
> Light dimming for Voltage 12-24V LED Driver
> Five distinct modes of operation selected via the
dip-switches (are alternatives to each other):
1) On/Off (just On/Off); 2) Push dimming (A slow/fast profile, profile B); 3) DALI; 4) Dimming 0-10V; 5) Dimming 1-
10V.
> Dimming Time (0-100 %, 100-0 %): A = 10 seconds, B = 5 seconds;
> Restart after a power failure, resumption of the last set point;
> Low level in Push is different from 0 to distinguish it from OFF.
> Push Dimming:
Setting A slow (set via DIP): each time dimming continues up to the maximum (or minimum) and then reverses. Time
from minimum to maximum, 10secs;
Setting A fast (set via DIP): each time the dimming continues up to the maximum (or minimum) and then reverses.
Time from minimum to maximum , 5secs ;
Setting B (set via DIP): each time dimming reaches max or min it reverses its direction. Time from minimum to
maximum, 10secs . When there are a number of drivers in parallel in any system it is necessary to carry out an
alignment procedure in order to compensate for timing errors.
> 1-10V or 0-10V (set via DIP): you can use commercially available 1-10V (0- 10V) dimmer s. The LED brightness varies
proportionally to the signal sent to the terminal. You can use 100K potentiometers. The variation of the brightness of the
LED is proportional or logarithmic, depending on the model of the potentiometer (recommended logarithmic) Using
dimmers active and domotic systems (impedance 130K) or passive (Iout max 1,4mA)
> Slave (set via DIP): you can use DL-D/P as Slave
> Available only Slave for signal repeating (DL-S)
> Complying with EN61347-2-13, EN61347-1, EN62384, EN55015, EN61000-3-2, EN61547
MADE IN ITALY
Lifetime terminal block 1x 2.5 mm2
Strain relief for 4 ... 6mm diameter cables
Data sheet
Back to Top