DL/DP Dimmer Led - Light dimming for Driver LED 12-48V

Suitable product for elevators

Six distinct modes of operation selected

On/Off (just On/Off)

Power on/off only

Push dimming (A slow/fast profile, profile B)

Setting A slow (set via DIP): each time dimming continues up to the maximum (or minimum) and then reverses. Time
from minimum to maximum, 10secs;
Setting A fast (set via DIP): each time the dimming continues up to the maximum (or minimum) and then reverses.
Time from minimum to maximum , 5secs ;
Setting B (set via DIP): each time dimming reaches max or min it reverses its direction. Time from minimum to
maximum, 10secs . When there are a number of drivers in parallel in any system it is necessary to carry out an
alignment procedure in order to compensate for timing errors.

DALI

Factory configuration - Power on: 100% - System fail level: 100%

Dimming 0-10V and Dimming 1-10V

1-10V or 0-10V (set via DIP): you can use commercially available 1-10V (0- 10V) dimmer s. The LED brightness varies
proportionally to the signal sent to the terminal. You can use 100K potentiometers. The variation of the brightness of the
LED is proportional or logarithmic, depending on the model of the potentiometer (recommended logarithmic) Using
dimmers active and domotic systems (impedance 130K) or passive (Iout max 1,4mA)

Slave

You can use DL-D/P as Slave

MADE IN ITALY